Cisco 7925G-EX - Connecting Your Phone; Installing the Phone Battery

For more information, see …
DescriptionItem
WLAN Settings
Assigns the Service Set Identifier (SSID) to this
profile. You must assign the same SSID to the
phone that is also assigned to access points in the
wireless network.
SSID
802.11 Standards for WLAN
Communications
Determines the signal mode or priority for
selecting signal modes available in the WLAN.
Options are:
•
802.11 b/g: Use only 2.4 GHz band
•
802.11a: Use only 5 GHz band
•
Auto, 802.11b/g preferred over 802.11a
(dual-band)
•
Auto, 802.11a preferred over 802.11b/g
(dual-band)
The preferred band, if available, is used
at power-on, but the phone may switch
to the less-preferred 2.4 GHz band, if
available, and the preferred band is lost.
After the phone has connected to the
less-preferred band, it does not scan for
the preferred band if the current band is
acceptable, and will remain connected
to the less-preferred band.
Note
•
Auto, signal strength (RSSI): Use strongest
signal in dual-band environment
WLAN Mode
802.11 Standards for WLAN
Communications
Set for the type of power saving mode used in the
WLAN. Options are:
•
U-APSD/PS-Poll
•
None
Call Power Save
Mode
WLAN Security
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
7
Wavelink Avalanche Server
Profile Settings Fields