A-2
Cisco 800 Fast Step Software Design Guide
OL-10373-02
Chapter A Additional Flags and Parameters
DHCPLeaseMinsOnE0 Number of minutes for the DHCP lease. This flag is used
only when the router is configured as a DHCP server.
(Used with the DHCPLeaseHoursOnE0 and
DHCPLeaseDaysOnE0 flags.)
DHCPNetworkAddressOnE0 Network address of the device from which a router with
a DHCP server enabled can lease an Internet Protocol
(IP) address.
DHCPNetworkSubnetMaskOnE0 The subnet mask for the DHCPNetworkAddressOnE0
flag.
DHCPPoolNameOnE0 Name of the DHCP pool created on the router. This flag
is used only when router is set as a DHCP server.
EnablePassword Enable password for the router.
HideAddressRange Hides the “Address range given by your Internet service
provider” control on the IP Address Range Given By
Your ISP window. If the value is 0 or blank, it is disabled
(displays the control). If the value is 1, it is enabled
(hides the control).
HideCentralRouternameISP Hides the “Central Routername for connection to an
Internet Service Provider” control on the PPP Settings
window. If the value is 0 or blank, it is disabled (displays
the control). If the value is 1, it is enabled (hides the
control).
HideCentralRouternameRCN Hide the “Central Routername for connection to Remote
Corporate Network” control on the PPP Settings window.
If the value is 0 or blank, it is disabled (displays the
control). If the value is 1, it is enabled (hides the control).
HideNetworkAddress Hides the “Network Address given by your ISP” control
on the IP Address Range Given By Your ISP window. If
the value is 0 or blank, it is disabled (displays the
control). If the value is 1, it is enabled (hides the control).
HidePAT Hides the “No Address range given by your ISP” control
on the IP Address Range Given By Your ISP window. If
the value is 0 or blank, it is disabled (displays the
control). If the value is 1, it is enabled (hides the control).
HideProtocolNotSure Hides the “Not sure” option in the Serial Connection
Type window. If the value is 0 or blank, it is disabled
(displays the control). If the value is 1, it is enabled
(hides the control).
PasswordISP Password for a PPP connection to an Internet service
provider (ISP).
To Next Page
Loading...
