A-3
Cisco 800 Fast Step Software Design Guide
OL-10373-02
Chapter A Additional Flags and Parameters
PasswordRCN Password for a PPP connection to a remote corporate
network.
PrimaryDNSAddressOnE0 Primary Domain Name System (DNS) address used to
configure the clients with the required DNS address
when the router is being used as a DHCP server. (See also
SecondaryDNSAddressOnE0.)
PrimaryWINSAddressOnE0 Primary WINS address used to configure the clients with
the required WINS address when the router is being used
as a DHCP server. (See also
SecondaryWINSAddressOnE0.)
ReadonlyPassword Read-only password for the router.
RemotePhoneNumberISP1,
RemotePhoneNumberISP2,
RemotePhoneNumberRCN1,
RemotePhoneNumberRCN2
Technical support phone numbers displayed in the
Technical Support window.
RouterName Name given to the router.
SecondaryDNSAddressOnE0 Secondary DNS address used to configure the clients
with the required DNS address when the router is being
used as a DHCP server. (See also
PrimaryDNSAddressOnE0.)
SecondaryWINSAddressOnE0 Secondary WINS address used to configure the clients
with the required WINS address when the router is being
used as a DHCP server. (See also
PrimaryWINSAddressOnE0.)
ServiceProviderURL Technical support Web site for the Technical Support
pop-up window.
SetAdjustPCStackSettings Router connection type. If the value is blank or 0, the
console cable connection is used, and the PC stack
settings are not changed. If the value is 1, the network is
used to configure the router.
SetRouterAsDHCPServerOnE0 Configures the router as a DHCP server on the LAN. If
the value is 0 or blank, the PC is also configured as a
DHCP client, so it can communicate with the router. If
this flag is set to 1 and the
SetForceStaticAddressOnPCAlways flag is set to 1, this
flag is given preference.
SetRouterToDefaultConfig Sets the router to the factory default configuration. When
this flag is enabled, the Erase Configuration window is
skipped. Enabled = 1. Disabled (default) = 0.
To Next Page
Loading...
