Check the resistance value of the ESD-preventive strap periodically. The measurement should be between 1
and 10 megohms.
Note
Before you perform any of the procedures in this guide, attach an ESD-preventive strap to your wrist and
connect the leash to the chassis as shown in the figures below.
Figure 1: ESD Label Information on Router Chassis
Figure 2: ESD Label Information on Cisco ASR 9910 Router Chassis
Figure 3: Connecting an ESD-Preventive Wrist Strap to the Cisco ASR 9010 Router Chassis
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
3
Preparing for Installation
Preventing Electrostatic Discharge Damage
To Next Page
Loading...
Need help?
General
