Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
How to Configure ANCP on Cisco ASR 9000 Series Routers
QC-96
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
Configuring ANCP Server Sender Name
The ANCP server sender name is used by the ANCP server in adjacency protocol messages to DSLAMs.
SUMMARY STEPS
1. configure
2. ancp server sender-name {H.H.H | A.B.C.D}
3. end
or
commit
Step 3
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-an
cp)# end
or
RP/0/RSP0/CPU0:router(config-an
cp)# commit
Saves configuration changes.
• When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
exiting (yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
–
Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
–
Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
• Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Step 4
show ancp summary
[statistics][detail]
Example:
RP/0/RSP0/CPU0:router# show
ancp summary
(Optional) Displays ANCP summary and general configuration
information.
Command or Action Purpose
To Next Page
Loading...
Need help?
General
