Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Configuration Examples for Configuring ANCP on Cisco ASR 9000 Series Routers
QC-110
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
Port count by state:
State Up 1
State Down 0
State Unknown 0
----------------------------------
Total 1
No. configured ports 1
No. mapped sub-interfaces 4
The following example shows how to display rate adjustment configuration information in addition to
the generic information shown in the previous example:
show ancp summary detail
ANCP Summary Information
----------------------------------------------
Capability: Topology Discovery
Server sender-name: 0013:1aff.c2bd
Neighbor count by state:
- 0
SYNSENT 0
SUNRCVD 0
ESTAB 1
----------------------------------
Total 1
Port count by state:
State Up 1
State Down 0
State Unknown 0
----------------------------------
Total 1
No. configured ports 1
No. mapped sub-interfaces 4
Rate adjustment configuration:
-------------------------------------------
DSL Type Loop Type Percent-Factor
-------------------------------------------
ADSL1 ETHERNET 90
ADSL2 ETHERNET 100
ADSL2PLUS ETHERNET 100
VDSL1 ETHERNET 100
VDSL2 ETHERNET 100
SDSL ETHERNET 100
ADSL1 ATM 100
ADSL2 ATM 100
ADSL2PLUS ATM 100
VDSL1 ATM 100
VDSL2 ATM 100
SDSL ATM 100
The following example shows how to display a summary of ANCP message statistics:
show ancp summary statistics
ANCP Summary Message Statistics
--------------------------------------
Sent Received
SYN 3 6
SYNACK 4 0
ACK 7105 2819
To Next Page
Loading...
Need help?
General
