Configuring Modular QoS Congestion Avoidance on Cisco ASR 9000 Series Routers
How to Configure Modular QoS Congestion Avoidance on Cisco ASR 9000 Series Routers
QC-78
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
Step 5
bandwidth {
bandwidth
[
units
] | percent
value
}
or
bandwidth remaining [percent
value
|
ratio
ratio-value
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# bandwidth
percent 30
or
RP/0/RSP0/CPU0:router(config-pmap-c)# bandwidth
remaining percent 20
(Optional) Specifies the bandwidth allocated for a class
belonging to a policy map.
or
(Optional) Specifies how to allocate leftover bandwidth to
various classes.
Note One of these configurations is required for a
non-default class.
Step 6
shape average {percent
percentage
|
value
[
units
]}
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# shape
average percent 50
(Optional) Shapes traffic to the specified bit rate or a
percentage of the available bandwidth.
Step 7
exit
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# exit
Returns the router to policy map configuration mode.
Step 8
exit
Example:
RP/0/RSP0/CPU0:router(config-pmap)# exit
Returns the router to global configuration mode.
Step 9
interface
type
interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
TenGigE 0/2/0/0
Enters configuration mode and configures an interface.
Command or Action Purpose
To Next Page
Loading...
Need help?
General
