1
Cisco Aironet Series 1700/2700/3700 Access Point Deployment Guide
Cisco Aironet Series 3700 Access Point
Figure 24 A Metal Pin or Padlock Will Not Deteriorate Over Time So It is Better Than a Plastic Tie
Warehouse and Factory
Warehouse installations are often difficult because of the very high ceilings and the clutter of the material being warehoused.
When performing a coverage check (site survey) always check the coverage at “full stock” levels because the material being
warehoused can change the RF coverage creating loss of uniform coverage. Also, try to position the APs as close to the users,
perhaps lowering the antennas when possible or practical to do so. If the AP is 30 feet in the air, that is, the signal has to go 30
feet further, “best case”. When configuring coverage for aisles, try to use directional (Patch) antennas on the wall and shoot
down the aisles; or use low-gain Omni-directional antennas on the ceiling (such as dipoles) or units with integrated antennas
because high gain omni-directional antennas tend to have more nulls. See Figure 25.
Another option is to mount the AP lower using pipe and electrical box mounting techniques.
To Next Page
Loading...
