11
Figure 3 Back of the AP
1
Mode button
4
Console port, under a mylar cover.
You will require the custom four-pin adapter
AIR-CONSADPT= to use this port.
2
10/100/1000BASE-T PoE uplink port.
This port supports:
• Inline power capability
• Auto-MDIX (automatically support
either straight through or crossover
cables)
802.3af/at power over the Ethernet interface
5
Passive Pass-Through port.
It is an RJ-45 port, from the back of AP to the
base of the AP.
3
Recess for the hook feature of wall-plate. The
AP attaches to the wall-plate by means of this
recess of the wall-plate hook.
To Next Page
Loading...
