Cisco ASR 9000 Series Configuration Manual

Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
How to Configure Serial Interfaces
539
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
OL-26061-03
11. feedback disable
12. max-header number-of-bytes
13. end
or
commit
DETAILED STEPS
Command or Action Purpose
Step 1
config
Example:
RP/0/RSP0/CPU0:router# configure
Enters global configuration mode.
Step 2
iphc profile profile-name type {cisco | ietf |
iphc}
Example:
RP/0/RSP0/CPU0:router(config)# iphc profile
Profile_1 type iphc
Creates an IPHC profile, sets the compression format
type, and enters the IPHC profile configuration mode.
Step 3
tcp compression
Example:
RP/0/RSP0/CPU0:router(config-iphc-profile)# tcp
compression
Enables TCP compression in an IPHC profile.
Step 4
tcp context absolute number-of-contexts
Example:
RP/0/RSP0/CPU0:router(config-iphc-profile)# tcp
context absolute 255
Configures the maximum number of TCP contexts that
are allowed for IPHC on a line card.
Step 5
non-tcp compression
Example:
RP/0/RSP0/CPU0:router(config-iphc-profile)# non-tcp
compression
Enables non-TCP compression in an IPHC profile.
Step 6
non-tcp context absolute number-of-contexts
Example:
RP/0/RSP0/CPU0:router(config-iphc-profile)# non-tcp
context absolute 255
Configures the maximum number of non-TCP contexts
that are allowed for IPHC on a line card.
Step 7
rtp
Example:
RP/0/RSP0/CPU0:router(config-iphc-profile)# rtp
Configures Real Time Protocol (RTP) on the interface.

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model