Cisco ASR 9000 Series - Page 10

Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router
Implementing a Satellite nV System
HC-716
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide
OL-26061-03
Step 7
ipv4 address address
Example:
RP/0/RSP0/CPU0:router(config-nV)# ipv4
address 10.22.1.2
Specifies the IP address to assign to the satellite. ICPE sets up a
connected route to the specified IP address through all configured
ICLs.
Step 8
end
or
commit
Example:
RP/0/0RSP0/CPU0:router(config)# end
or
RP/0/RSP0/CPU0:router(config)# commit
Saves configuration changes.
• When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
– Entering no exits the configuration session and returns the
router to EXEC mode without committing the
configuration changes.
– Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
• Use the commit command to save the configuration changes to
the running configuration file and remain within the
configuration session.
Command or Action Purpose