Cisco ASR 9001-S - Processor-To-Processor Communication; Route Processor;Fabric Interconnect; Figure 2-12 RP Component Interconnections; Figure 2-13 FC Component Interconnections

2-18
Cisco ASR 9000 Series Aggregation Services Router Overview and Reference Guide
OL-17501-09
Chapter 2 Functional Description
Route Processor Card
Figure 2-12 RP Component Interconnections
Figure 2-13 FC Component Interconnections
Processor-to-Processor Communication
The RSP/RP card communicates with the control processors on each line card through the Ethernet Over
Backplane Channel (EOBC) Gigabit Ethernet switch. This path is for processor-to-processor
communication, such as IPC (InterProcess Communication). The Active RSP/RP card also uses the EOBC
to communicate to the Standby RSP/RP card, if installed.
Route Processor/Fabric Interconnect
The RSP card has a fabric interface chip (FIC) attached to the switch fabric and linked to the Route
Processor through a Gigabit Ethernet interface through a packet diversion FPGA. This path is used for
external traffic diverted to the RSP card by line card network processors.
RP
302426
B
a
c
k
p
l
a
n
e
s
System
Timing
Arbiter
Control
Interface
GE
Switch
Punt
VOQ
Scheduler
Fabric
Interface
CPU
FC
302427
B
a
c
k
p
l
a
n
e
s
Control
Interface
Fabric
Interface
Fabric
Interface