Cisco ASR 9006 Installation Guide

Slide the card out of
the chassis.
cPivot the ejector
levers to unseat the
card from the
backplane connector.
bLoosen the captive
screws.
a
Figure 99: Removing a Line Card from the Cisco ASR 9910 Router Chassis
Step 3 Repeat for each RSP or line card.
Removing RP Cards, Fabric Cards, and Line Cards from the Cisco ASR 9922 Router and Cisco ASR
9912 Router
This section describes how to remove the Route Processor (RP) cards, Fabric Card (FC), and Line Cards
(LCs) from the Cisco ASR 9922 Router and Cisco ASR 9912 Router. The table below describes the components
and slot numbering for each router.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
91
Unpacking and Installing the Chassis
Removing RP Cards, Fabric Cards, and Line Cards from the Cisco ASR 9922 Router and Cisco ASR 9912 Router

Cisco ASR 9006 Specifications

General

Chassis Type	Modular
Rack Units	10 RU
Slots	6
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
Power Supply	AC or DC
Cooling	Front-to-back airflow
Input Voltage	100-240 VAC or -48 to -60 VDC
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	10GE, 40GE, 100GE
Management Interfaces	Ethernet, Console, Auxiliary