Cisco ASR 9006 Installation Guide

Figure 111: Installing the Cisco ASR 9010 Router Chassis in a Standard 2-Post Rack
Five screws per side (minimum) to attach the router
chassis to the rack
1
To install the Cisco ASR 9010 Router chassis in a Seismic 2-post rack for optional earthquake protection,
two side brackets must be mounted to the chassis for attachment to the posts (5” channel width) of the GR-63
Zone 4 Seismic 2-post rack.
Note
The below figure shows the orientation of the Cisco ASR 9010 Router chassis to the Seismic 2-post rack and
components used in the installation.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
105
Unpacking and Installing the Chassis
Installing the Chassis in a 2-Post Rack

Cisco ASR 9006 Specifications

General

Chassis Type	Modular
Rack Units	10 RU
Slots	6
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
Power Supply	AC or DC
Cooling	Front-to-back airflow
Input Voltage	100-240 VAC or -48 to -60 VDC
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	10GE, 40GE, 100GE
Management Interfaces	Ethernet, Console, Auxiliary