21
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.10S Releases
Symptom: IOMD crash is seen while performing an SSO when card type is not configured for T1E1
IM.
Conditions: This issue is observed when the TDM card type is not configured before performing an
SSO.
Workaround: Configure the card type for T1E1 IM before preforming an SSO.
• CSCuf20151
Symptom: The following error message is displayed when you apply a policy map:
QoS: Configuration failed. Can NOT match ACL in an output policy-map
Conditions: This issue is observed when you apply a policy map, reload, or reconfigure of the
policy map.
Workaround: There is no workaround.
• CSCuf43275
Symptom: The router does not detect traffic through GLC-FE-100EX and GLC-FE-100ZX
transceivers.
Conditions: The router does not support traffic through GLC-FE-100EX and GLC-FE-100ZX
transceivers.
Workaround: There is no workaround.
• CSCuf43992
Symptom: The router crashes if you configure local span.
Conditions: This issue is observed when you configure local span on the router.
Workaround: There is no workaround.
• CSCuf44077
Symptom: The show interface command output shows incorrect speed values after performing an
SSO.
Conditions: This issue is observed when you use a 100M SFP.
Workaround: There is no impact on functionality. Reset the hardware module to resolve this issue.
• CSCuf57632
Symptoms: When you reload the router, the device may not be able to load the startup configuration
from NVRAM.
Conditions: This issue is sometimes observed when you reload the router.
Workaround: Reload the router again.
To Next Page
Loading...
Need help?
General
