Cisco ASR 903 Release Notes

22
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.10S Releases
• CSCuf65012
Symptom: When you perform an IM OIR on slot 4, the router may display syslog messages from
the GigabitEthernet 0/5/0 port.
Conditions: This issue is observed when you perform an IM OIR on slot 4 and Slot 5.
Workaround: There is no workaround.
• CSCuf79364
Symptom: When you try configure speed on the interface on the standby machine, it does not accept
the command.
Conditions: This issue is observed after you insert a new IM and GE-T connector when router is
running.
Workaround: Reload the router before configuring the speed.
• CSCuf79504
Symptom: When you use the shutdown and no shutdown commands multiple times on the
controller, ATM VC creation on the standby RSP fails.
Conditions: This issue is observed when you use the shutdown and no shutdown commands
multiple times on the controller on active RSP.
Workaround: There is no workaround.
• CSCuf81085
Symptom: After you use the shutdown and no shutdown commands on the controller of PE, IMA
VCs go down.
Conditions: This issue is observed after using the shutdown and no shutdown commands on the
OC3 controller on PE routers.
Workaround: Use the shutdown and no shutdown commands on the controller.
• CSCuf85460
Symptom: When you delete the POS interface and try to create an ATM interface, the following
error message is displayed:
%OC3.STS1 0/2/0.1:Port type not supported
Insufficient resources to create channel group
Conditions: This issue is observed when you reload the OC3-IM having POS interface and try to
create an ATM interface.
Workaround: Create the POS interface, delete it, and the create an ATM interface.
• CSCuf89665
Symptom: Flow control identifiers of active and protect interfaces are not created on to the standby.
Due to which, the interface goes down when you perform an SSO.
Conditions: This issue is observed when you set up ACR on the standby machine.
Workaround: There is no workaround.
• CSCuf89844
Symptom: The router crashes when you delete a BDI interface running BFD.
Conditions: This issue is observed when you assign a static MAC address on a neighbor router or
on one of the BDI interfaces on the Cisco ASR 903 router, and delete the BDI interface running BFD
on the Cisco ASR 903 router.

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1