Cisco ASR 920 series - Verifying Control Plane Services

PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Enters control-plane configuration mode (which is a prerequisite
for defining control plane services).
control-plane
Example:
Device(config)# control-plane
Step 3
Attaches a QoS service policy to the control plane.
service-policy inputpolicy-map-name
Step 4
Example:
Device(config-cp)# service-policy input
control-plane-policy
• input—Applies the specified service policy to packets
received on the control plane.
• policy-map-name—Name of a service policy map (created
using the policy-map command) to be attached.
(Optional) Returns to privileged EXEC mode.end
Example:
Device(config-cp)# end
Step 5
Verifying Control Plane Services
SUMMARY STEPS
1.
enable
2.
show policy-map control-plane [all] [input [class class-name]]
3.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Displays information about the control plane.show policy-map control-plane [all] [input
[class class-name]]
Step 2
• all—(Optional) Displays service policy information about all QoS
policies used on the CP.
QoS: Policing and Shaping Configuration Guide (Cisco ASR 920 Series)
37
Control Plane Policing
Verifying Control Plane Services