! Configure GEC interface
Device(config)# interface GigabitEthernet 0/0/2
Device(config-if)# no ip address
Device(config-if)# channel-group 1 mode active
Device(config-if)# exit
The show mpls traffic-eng tunnels command output displays information about a tunnel or one–line
information about all tunnels configured on the device:
Device# show mpls traffic-eng tunnels tunnel 14
Name: ASR1013_t14 (Tunnel10) Destination: 10.4.4.4
Status:
Admin: up Oper: up Path: valid Signalling: connected
path option 1, type explicit toR4overR3R3 (Basis for Setup, path weight 3)
Config Parameters:
Bandwidth: 0 kbps (Global) Priority: 7 7 Affinity: 0x0/0xFFFF
Metric Type: TE (default)
AutoRoute: enabled LockDown: disabled Loadshare: 0 [0] bw-based
auto-bw: disabled
Active Path Option Parameters:
State: explicit path option 1 is active
BandwidthOverride: disabled LockDown: disabled Verbatim: disabled
InLabel : -
OutLabel : Port-channel1, 1608
Next Hop : 172.16.1.2
FRR OutLabel : Tunnel23, 4868
RSVP Signalling Info:
Src 10.1.1.1, Dst 10.4.4.4, Tun_Id 14, Tun_Instance 35
RSVP Path Info:
My Address: 172.12.1.1
Explicit Route: 172.12.1.2 172.23.1.1 172.23.1.2 172.34.1.1
172.34.1.2 10.4.4.4
History:
Tunnel:
Time since created: 17 hours
Time since path change: 18 minutes, 22 seconds
Number of LSP IDs (Tun_Instances) used: 35
Current LSP: [ID: 35]
Uptime: 18 minutes, 22 seconds
Selection: reoptimization
Prior LSP: [ID: 32]
ID: path option unknown
Removal Trigger: signalling shutdown
Device# show mpls traffic-eng tunnels brief
show mpls traffic-eng tunnels brief
Signalling Summary:
LSP Tunnels Process: running
Passive LSP Listener: running
RSVP Process: running
Forwarding: enabled
Periodic reoptimization: every 3600 seconds, next in 3299 seconds
Periodic FRR Promotion: Not Running
Periodic auto-bw collection: every 300 seconds, next in 299 seconds
P2P TUNNELS/LSPs:
TUNNEL NAME DESTINATION UP IF DOWN IF STATE/PROT^M
ASR1013_t14 10.4.1.1 - Po12 up/up
On Mid Router:
P2P TUNNELS/LSPs:
TUNNEL NAME DESTINATION UP IF DOWN IF STATE/PROT
ASR1013_t14 10.4.1.1 Po12 Po23 up/up
ASR1002F_t23 10.2.1.1 Po25 - up/up
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR
920 Series)
7
MPLS Traffic Engineering – Bundled Interface Support
Example: Configuring MPLS TE - Bundled Interface Support over Gigabit Etherchannel
To Next Page
General
