Bandwidth: 0 kbps (Global) Priority: 5 5 Affinity: 0x0/0xFFFF
Metric Type: TE (default)
AutoRoute: disabled LockDown: disabled Loadshare: 0 [0] bw-based
auto-bw: disabled
Active Path Option Parameters:
State: dynamic path option 1 is active
BandwidthOverride: disabled LockDown: disabled Verbatim: disabled
InLabel : -
OutLabel : BDI31, 21
Next Hop : 12.0.0.2
RSVP Signalling Info:
Src 1.1.1.1, Dst 3.3.3.3, Tun_Id 5, Tun_Instance 1
RSVP Path Info:
My Address: 12.0.0.1
Explicit Route: 12.0.0.2 14.0.0.2 14.0.0.1 3.3.3.3
Record Route: NONE
Tspec: ave rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
RSVP Resv Info:
Record Route: NONE
Fspec: ave rate=0 kbits, burst=1000 bytes, peak rate=0 kbits
Shortest Unconstrained Path Info:
Path Weight: 2 (TE)
Explicit Route: 12.0.0.1 12.0.0.2 14.0.0.2 14.0.0.1
3.3.3.3
History:
Tunnel:
Time since created: 1 minutes, 38 seconds
Time since path change: 1 minutes, 36 seconds
Number of LSP IDs (Tun_Instances) used: 1
Current LSP: [ID: 1]
Uptime: 1 minutes, 36 seconds
Configuration Example for MPLS Traffic Engineering over BDI
The following example enables the BDI on the router:
Router(config)#interface bdi30
Router(config-if)#mpls traffic-eng tunnels
Configuring Interface Tunnel Example
The following example configures an interface tunnel
interface Tunnel1
ip unnumbered Loopback0
tunnel source Loopback0
tunnel mode mpls traffic-eng
tunnel destination 4.4.4.4
tunnel mpls traffic-eng path-option 1 dynamic
Configuring RSVP Bandwidth Example
The following example configures RSVP bandwidth
ip rsvp bandwidth [ interface-kbps] [single-flow-kbps]
Router(config-if)# ip rsvp bandwidth 500 500
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco
ASR 920 Series)
48
MPLS Traffic Engineering over Bridge Domain Interfaces
Configuration Example for MPLS Traffic Engineering over BDI
To Previous Page
Loading...
Need help?
General
