Cisco ASR 920 series - Verifying that MPLS te over BDI Is Operational; Troubleshooting Tips

PurposeCommand or Action
(Optional) Returns to privileged EXEC mode.end
Example:
Router(config-if)# end
Step 5
Verifying That MPLS TE over BDI Is Operational
To verify that MPLS TE over BDI can function, perform the following task.
SUMMARY STEPS
1.
enable
2.
show mpls traffic-eng tunnels brief
3.
show mpls traffic-eng tunnels summary
4.
show mpls traffic-eng tunnels tunnel1
DETAILED STEPS
Step 1
enable
Enables privileged EXEC mode.
Step 2
show mpls traffic-eng tunnels brief
Use this command to monitor and verify the state of the tunnels.
Step 3
show mpls traffic-eng tunnels summary
Use this command to monitor and verify the state of the tunnels.
Step 4
show mpls traffic-eng tunnels tunnel1
Use this command to verify that tunnels are up and using BDI.
Troubleshooting Tips
This section describes how you can use the show mpls traffic-eng tunnels tunnel5 to check for issues.
Router# show mpls traffic-eng tunnels tunnel5
Name: router_t5 (Tunnel5) Destination: 3.3.3.3
Status:
Admin: up Oper: up Path: valid Signalling: connected
path option 1, type dynamic (Basis for Setup, path weight 2)
Config Parameters:
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR
920 Series)
47
MPLS Traffic Engineering over Bridge Domain Interfaces
Verifying That MPLS TE over BDI Is Operational