Cisco ASR 920 series Configuration

Using FRR to Protect P2MP TE Links 18
FRR Failure Detection Mechanisms 20
Bandwidth Preemption for P2MP TE 20
How to Configure MPLS Point-to-Multipoint Traffic Engineering 21
Configuring the Headend Routers 21
Configuring the Midpoint Routers 24
Configuring the Tailend Routers 25
Configuring FRR with P2MP TE Tunnels 27
Enabling MPLS Traffic Engineering System Logging of Events 27
Verifying the Configuration of MPLS Point-to-Multipoint Traffic Engineering 28
Verifying the Configuration of the Headend Router 28
Verifying the Configuration of the Midpoint Routers 30
Verifying the Configuration of the Tailend Routers 31
Configuration Examples for MPLS Point-to-Multipoint Traffic Engineering 33
Example Configuration of the Headend Router (PE5) 33
Example Configuration of the Midpoint Router (P1) 36
Example Configuration of the Tailend Router (PE1) 37
Additional References 38
Feature Information for MPLS Point-to-Multipoint Traffic Engineering 39
Glossary 40
CHAPTER 3 MPLS Traffic Engineering over Bridge Domain Interfaces 43
Prerequisites for Configuring MPLS TE over BDI 43
Restrictions for MPLS TE over BDI 44
Information About MPLS Traffic Engineering over BDI 44
Features of MPLS Traffic Engineering over BDI 44
Supported Features 44
How to Configure MPLS Traffic Engineering over BDI 44
Configuring MPLS TE over BDI 45
Configuring the RSVP Bandwidth 46
Verifying That MPLS TE over BDI Is Operational 47
Troubleshooting Tips 47
Configuration Example for MPLS Traffic Engineering over BDI 48
Configuring Interface Tunnel Example 48
Configuring RSVP Bandwidth Example 48
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco
ASR 920 Series)
iv
Contents

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English