Cisco C1111 8P Series

To Next Page

To Previous Page

Figure 61: LTE USB 2.0 Dongle for C1101-4P

DescriptionNumber

Supporting ring1

Magnet2

Extend outward 30mm3

Plug-in direction4

DescriptionNumber

Supporting ring1

Dongle holder with magnet2

Router-C1101-4PLTEPW3

Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router

Install and Upgrade Internal Modules and Field Replaceable Units

Install a Micro-SIM Card into a USB LTE Dongle

Main Page

Table of Contents3
Overview of Cisco 1000 Series Integrated Services Routers7
About Cisco 1000 Series Integrated Service Routers7
Chassis Views10
LED Indicators19
Reset Button26
Power Supply26
Slots and Interfaces27
About Slots, Subslots, and Port Numbering27
Specifications of Cisco 1100 Series Integrated Services Routers27
Periodic Inspection and Cleaning27
Prepare for Router Installation29
Safety Recommendations29
Safety with Electricity30
Prevent Electrostatic Discharge Damage30
General Site Requirements30
Site Selection Guidelines31
Rack Requirements31
Safety Recommendations32
Power Guidelines and Requirements32
Network Cabling Specifications33
Console Port Considerations33
Eia/Tia-23233
USB Serial Console33
Console Port Considerations34
Prepare for Router Installation35
Ethernet Connections35
Required Tools and Equipment for Installation and Maintenance35
Install and Connect the Router37
Unpack the Router37
Set up Router on Desktop, Rack, or Wall37
Rack Mount38
Attach the Brackets for C111X38
Attach the Rack Mounting Brackets for C112X39
Mount the Router40
Mount the Router under a Desk or a Shelf41
Mount Router Using DIN Rail Brackets42
Attach Din-Rail Brackets on C112X43
Wall Mount the Router44
Wall Mount Using Key-Hole Slots44
Wall Mount Using DIN Rail Brackets51
Chassis Grounding54
Connect Power Cable56
Connect the Router to a Console58
Connect to the Serial Port with Microsoft Windows60
Connect to the Console Port with Mac os X61
Connect to the Console Port with Linux61
Connect WAN and LAN Interfaces62
Ports and Cabling62
Connection Procedures and Precautions63
Configure the Router at Startup63
Install and Upgrade Internal Modules and Field Replaceable Units65
Replace the Chassis Covers for C111X and C1111X65
Remove the Cover66
Replace the Cover67
External Modules68
Locate External Slots for Modules68
Install and Remove Small Form Pluggable Modules69
Install Small Form Pluggable Module69
Remove Small Factor Pluggable Module69
Install an LTE Pluggable Module70
Install an LTE Pluggable Module on a C1101-4P71
Install a Micro-SIM Card into a USB LTE Dongle75
Antenna Mounting Instructions78
Rack Mount of the Antenna78
Wall Mount of the Antenna80
Ceiling Mount of the Antenna82
ROM Monitor Overview85
Supplier Declaration of Conformity87

Cisco C1111 8P Series - Page 77

Table of Contents

Related product manuals