Cisco C395 User Manual

Power supply (one LED for each power supply):
• Off—No AC input (12-V main power off;
12-V standby power off)
• Green, flashing—12-V main power off; 12-V
standby power on.
• Green—12-V main power on; 12-V standby
power on.
• Amber, flashing—Warning threshold
detected but 12-V main power on.
• Amber—Critical error detected; 12-V main
power off (for example, overcurrent,
overvoltage, or overtemperature failure).
6Rear unit identification:
• Off—The unit identification function is not
in use.
• Blue, flashing—The unit identification
function is activated.
5
Power Supply
The power supply is hot-swappable. For the C195, you can order a second power supply for redundancy as
1+1. The C395, C695, and C695F ship with two power supplies thus providing for redundancy.
Make sure that one power supply is always active.
Note
The following table lists the specifications for the 770-W AC power supply (Cisco part number 341-0591-04)
used in the ESA C195, C395, C695, and C695F.
Table 2: 770-W Power Supply Specifications
SpecificationDescription
Nominal range: 100 to 120 V AC, 200 to 240 V AC
Range: 90–132 V AC, 180–264 V AC
AC input voltage range
Nominal range: 50–60 Hz
Range: 47–63 Hz
AC input frequency
9.5 A peak at 100-V AC
4.5 A peak at 208 V AC
Maximum AC input current
950 VA at 100 V ACMaximum input volt amperes
770 WMaximum output power for each power supply
15 A (subcycle duration)Maximum inrush current
12 ms at 770 WMaximum hold-up time
Cisco Email Security Appliance C195, C395, C695, and C695F Hardware Installation Guide
14
Overview
Power Supply

Cisco C395 Specifications

General

Brand	Cisco
Model	C395
Category	Security System
Language	English