CHAPTER 2
Installation Preparation
• Installation Warnings, on page 25
• Safety Recommendations, on page 27
• Maintain Safety with Electricity, on page 27
• Prevent ESD Damage, on page 28
• Site Environment, on page 28
• Site Considerations, on page 28
• Power Supply Considerations, on page 29
• Rack Configuration Considerations, on page 29
Installation Warnings
Read the Regulatory Compliance and Safety Information document before installing the chassis.
Take note of the following warnings:
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. Read the installation instructions before using,
installing, or connecting the system to the power source. Use the statement number provided at the end
of each warning statement to locate its translation in the translated safety warnings for this device.
SAVE THESE INSTRUCTIONS
Warning
Statement 1005—Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not great than: 250 V, 15 A.
Warning
Cisco Email Security Appliance C195, C395, C695, and C695F Hardware Installation Guide
25
To Next Page
Loading...
