Cisco C9200L-24P-4G User Manual

Weight does not include the functional uplink modules, the blank modules, or the power supplies
Table 18: Weight Measurements
WeightSwitch Model
10 lb (4.5 kg)C9200-24T
10 lb (4.5 kg)C9200-24P
10 lb (4.5 kg)C9200-48T
10 lb (4.5 kg)C9200-48P
9.6 lb (4.35 kg)C9200L-24T-4G
9.6 lb (4.35 kg)C9200L-24P-4G
9.6 lb (4.35 kg)C9200L-48T-4G
9.6 lb (4.35 kg)C9200L-48P-4G
9.0 lb (4.08 kg)C9200L-48T-4X
9.5 lb (4.31 kg)C9200L-48P-4X
8.5 lb (3.9 kg)C9200L-24P-4X
8.0 lb (3.63 kg)C9200L-24T-4X
This table describes the physical specifications.
Table 19: Physical Specifications for the Power Supplies
Weight
2 lb (0.9 kg)
PWR-C5-1KWAC
1.7 lb (0.77 kg)PWR-C5-600WAC
1.5 lb (0.68 kg)PWR-C5-125WAC
Dimensions (H x D x W)
The dimensions shown include the extraction handle and the keying feature.
1.58 x 4.0 x 7.6 in. (40.1 X 101.6 X 193 mm)
PWR-C5-1KWAC
PWR-C5-600WAC
PWR-C5-125WAC
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
71
Technical Specifications
Technical Specifications

Cisco C9200L-24P-4G Specifications

General

Model	C9200L-24P-4G
Category	Switch
Ports	24 x 10/100/1000 (PoE+)
Switching Capacity	128 Gbps
Power Budget	370W
Layer	Layer 3
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Power Over Ethernet (PoE)	PoE+
RAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Routing Protocol	OSPF, EIGRP, BGP, IS-IS, RIP
Remote Management Protocol	SNMP 1, SNMP 3, CLI, HTTP, SSH
Features	VLAN support, DHCP support, Quality of Service (QoS), IGMP snooping
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.1s, IEEE 802.1w
Operating Temperature	0 to 45 °C
Operating Humidity	5% to 95% (non-condensing)