Mounting on a Wall
For the best support of the switch and cables, make sure that the switch is attached securely to wall studs or
to a firmly attached plywood-mounting backboard. Mount the switch with the front panel facing down.
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware
or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
Statement 378
Warning
Following safety regulations, wall-mount the switch with its front panel facing down.
Caution
Figure 13: Mounting on a Wall
User-supplied screws (for example, you can use # 6
wood screws with a washer head 1-inch long).
1
When you complete the switch installation, see After Switch Installation, on page 24 for information on
switch configuration.
Installing the Switch on a Table or Shelf
SUMMARY STEPS
1. To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope.
2. Attach the four rubber feet to the four circular etches on the bottom of the chassis.
Cisco Catalyst 2960-L Smart Managed Series 24-Port and 48-Port Switch Hardware Installation Guide
23
Switch Installation
Mounting on a Wall
To Next Page
Loading...
