Cisco Catalyst 2960-L Getting Started Guide

Cisco Catalyst 2960-L Switch Getting Started
Guide
Getting Started with the Switch
Getting Started with the Switch
•
About the document
This guide provides instructions for the initial set up of your Cisco Catalyst 2960-L switch. It includes basic
rack-mounting, desk and shelf mounting for the switch, port and module connection procedures, and
troubleshooting information.
Before installing or upgrading the switch, refer to the Cisco Catalyst 2960-L switch Release Notes available
on cisco.com.
Note
Cisco Catalyst 2960-L Switch Getting Started Guide
1

Cisco Catalyst 2960-L Specifications

General

Subtype	Gigabit Ethernet
Power Device	Internal power supply
Stacking	Not supported
Model	Catalyst 2960-L
Uplink Interfaces	4 x Gigabit SFP
Power Supply	Internal
Device Type	Switch
Routing Protocol	Static IP routing
Features	VLAN support, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x, IEEE 802.1w, IEEE 802.1s
Memory	256 MB Flash
Dimensions	1.73 in x 17.5 in x 9.4 in
Operating Temperature	32 to 113°F (0 to 45°C)