Cisco Catalyst 2960-L - Connecting to the Switch Ports

Number-12 Phillips pan-head screws
(48-0523-01) or Number-10 Phillips pan-head
screws (48-0627-01)
4Cable guide1
Mid-mounting position5Phillips machine screw, black (48-0654-01)2
Rear-mounting position6Front-mounting position3
Connecting to the Switch Ports
This section describes how to connect to the fixed switch ports and to the Small Form-Factor Pluggable (SFP)
module ports.
Connecting to the 10/100/100 or 10/100/1000 PoE+ Ports
The fixed ports on the Cisco Catalyst 2960-L Power over Ethernet Plus (PoE+) switches provide:
•
PoE+ support for IEEE 802.3at-compliant powered devices
•
PoE support for IEEE 802.3af-compliant powered devices
These ports also provide Cisco prestandard PoE support for Cisco IP phones and Cisco Aironet Access Points.
See the Cisco Catalyst 2960-L Hardware Installation Guide for information on PoE budgeting. By default,
a switch PoE port automatically provides power when a compliant device is connected, including PoE, and
PoE+.
Cisco Catalyst 2960-L Switch Getting Started Guide
14
Getting Started with the Switch
Connecting to the Switch Ports