14
Step 8 Click Advanced Configuration, and enable these switch module features:
a. External management over all ports
b. Preserve new IP configuration on all resets
The default setting is Disabled for these features.
Note If you have connected the StackWise Plus cables, the Advanced Configuration settings
are not available. To access the Advanced Configuration settings, disconnect the
StackWise Plus cables.
Step 9 Click Save to save your settings.
Step 10 Exit the aMM web interface.
Step 11 Go to “Running Express Setup” to complete the switch module setup.
Running Express Setup
To complete the Express Setup program, you will need this information from your system
administrator:
• Switch module password
• Telnet access password
• Names of the SNMP read and write community strings if you are going to use a
network-management program like CiscoWorks (optional)
• Host name, system contact, and system location (optional)
Follow these steps:
Step 1 Launch a web browser on a PC that is connected to the Internet. Enter the IP address that you
assigned in Step 7 of the “Assigning the Switch Module IP Address” procedure in the web
browser, and press Enter.
To Next Page
Loading...
Need help?
General