EasyManua.ls Logo

Cisco Catalyst 3560-CX

Cisco Catalyst 3560-CX
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Follow these steps to assign a priority value to a stack member:
SUMMARY STEPS
1. enable
2. switch stack-member-number priority new-priority-number
3. show switch stack-member-number
4. copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Step 1
Switch enable
Specifies the stack member number and the new priority
for the stack member. The stack member number range is
1 to 8. The priority value range is 1 to 15.
switch stack-member-number priority new-priority-number
Example:
Switch# switch 3 priority 2
Step 2
You can display the current priority value by using the show
switch user EXEC command.
The new priority value takes effect immediately but does
not affect the current stack master. The new priority value
helps determine which stack member is elected as the new
stack master when the current stack master or switch stack
resets.
Verify the stack member priority value.
show switch stack-member-number
Example:
Step 3
Switch# show switch
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Step 4
Switch# copy running-config startup-config
Provisioning a New Member for a Switch Stack
This optional task is available only from the stack master.
SUMMARY STEPS
1. show switch
2. configure terminal
3. switch stack-member-number provision type
Managing Switch Stacks
16
Managing Switch Stacks
Provisioning a New Member for a Switch Stack

Other manuals for Cisco Catalyst 3560-CX

Related product manuals