© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 17 of 54
Permanent RTU License
This is a paid license that does not expire. You can activate permanent RTU licenses after you accept the EULA.
The EULA assumes you have purchased the permanent license. There are two types of permanent RTU licenses:
●
Image-based (or feature set) license
●
Adder AP-Count license
Image-based license: This license is activated by Cisco before the switch is shipped and requires no customer
configuration to enable it. Supported license levels include LAN Base, IP Base, and IP Services.
You can upgrade, disable, or move image-based licenses by using the license right-to-use command, either for
individual switches or for all switches in a stack. Reload the switch or stack to activate the highest level license. For
example, if you upgrade the license level from IP Base to IP Services, then the IP services license is activated by
reloading the switch.
This command enables the ipservices license and accepts the EULA on all switches in the stack:
Adder AP-Count license: The adder AP-Count license is an “add as you grow” license. You can add access point
licenses as your network grows. You activate an adder AP-count license by using EXEC commands, and it is
activated without a switch reload.
This example shows the license summary display for a switch with an activated adder AP-Count license:
To Next Page
Loading...
Need help?
General
