© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 40 of 54
This example shows output from the show capwap summary command:
The show capwap summary command output shows that two data CAPWAP tunnels are formed with the Cisco
access points: Access point 3502E is connected to Gigabit Ethernet 2/0/25, and access point 3602I is connected to
Gigabit Ethernet 2/0/1.
The switch and wireless management IP address is 20.1.3.2. This is the source IP address that the switch uses to
form the data CAPWAP tunnels with the access points.
The access point IP addresses are the destination IP addresses: 20.1.3.54 on destination port 63584 and
20.1.3.53 on destination port 58274.
Configuring the Large Branch or Medium Size Campus Deployment
The single-switch network grows, and the network administrator needs to add more Cisco Catalyst 3850 Switches
and expand wireless coverage to more endpoints and devices.
The existing Cisco Catalyst 3850 Switch remains the mobility controller. Additional Cisco Catalyst 3850 Switches
are added and configured as mobility agents. The mobility agents can be configured in one switch peer group
(SPG). (See Figure 14).
Figure 14. Cisco Catalyst 3850 Switch Mobility Controller and SPG
To Next Page
Loading...
