© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 39 of 54
The next step is to configure service set identifiers (SSIDs), define wireless LAN (WLAN) on the switch, with
corresponding VLAN used for wireless clients, the authentication and ciphers method, and the AAA server profile
to use for this WLAN. In the following example, the name of the SSID is Cisco123, using the client VLAN 500 we
defined for wireless clients, and enabling WPA, WPA2 with TKIP, using 802.1X authentication with the AAA server
defined elsewhere in the configuration.
To configure an open SSID, use the no security wpa command in the WLAN configuration.
To configure preshared key (PSK) security, use these commands:
This example shows output from the show wireless mobility summary command:
This example shows output from the show wlan summary command:
To Next Page
Loading...
