© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 41 of 54
This example shows how to configure the SPG definitions and members on the mobility controller switch:
A switch peer group, SPG1, is defined on the mobility controller. The mobility agent switches included in SPG1 are
configured with the switch and wireless management IP addresses 20.1.5.2 and 20.1.7.2.
On the mobility agent switches, configure the mobility controller, SSID, WLAN, and authentication methods. This
example shows the configuration on the switch labeled MA1 in Figure 14:
The switch and wireless management IP address of the mobility controller switch is 20.1.3.2.
The switch and wireless management interface is VLAN 602.
The client VLAN that connects the mobility controller switch to the mobility agent switch is VLAN 500.
This example shows the configuration on the switch labeled MA2 in Figure 14:
To Next Page
Loading...
