Cisco Catalyst 9166I Series - Deploying the Access Point on the Wireless Network

Cisco Orderable Accessories
You can order the following accessories separately, from Cisco:
• AP-mounting brackets to mount the AP
DescriptionMounting Brackets
For low-profile non-pivoting installationsAIR-AP-BRACKET-1=
For electrical or network boxes above ceiling mountsAIR-AP-BRACKET-2=
Flush ceiling grid clipAIR-AP-T-RAIL-F=
Recessed ceiling grid clipAIR-AP-T-RAIL-R=
T-RAIL channel adapterAIR-CHNL-ADAPTER=
• Power injectors when Power over Ethernet (PoE) is not available
DescriptionPower Supply
Mid-span power injector AIR-PWRINJ7= when (PoE) is not
available
Power specifications: 50W, 56VDC
For more information, see the power injector data sheet.
AIR-PWRINJ7=
A 802.3at power injector when PoE is not available
Power Specifications: 30W, 55VDC
For more information, see the power injector data sheet.
AIR-PWRINJ6=
Meraki 802.3bt PoE injector
Power Specifications: 60W, 55VDC
For more information, see the power injector data sheet.
MA-INJ-6-x
DC power adapter
Power Specifications: 50W, 54VDC
MA-PWR-50WAC
Cisco Catalyst Wireless 9166I Series Wi-Fi 6E Access Point Hardware Installation Guide
16
Unpacking Your Access Point
Cisco Orderable Accessories