Cisco Catalyst 9300 Series

To Next Page

To Previous Page

ActionInterface

DisregardTenGigabitEthernet1/1/2

DisregardTenGigabitEthernet1/1/3

DisregardTenGigabitEthernet1/1/4

DisregardTenGigabitEthernet1/1/5

DisregardTenGigabitEthernet1/1/6

DisregardTenGigabitEthernet1/1/7

DisregardTenGigabitEthernet1/1/8

C9300-NM-4G Module

All ports in the C9300-NM-4G module are natively GigabitEthernet and are configured GigabitEthernet1/1/1

though GigabitEthernet1/1/4. There are only four interfaces that are valid, and the other four should not be

used even though they are available in the CLI.

Table 2: C9300-NM-4G Module

ActionInterface

Configure this interfaceGigabitEthernet1/1/1

Configure this interfaceGigabitEthernet1/1/2

Configure this interfaceGigabitEthernet1/1/3

Configure this interfaceGigabitEthernet1/1/4

DisregardTenGigabitEthernet1/1/1

DisregardTenGigabitEthernet1/1/2

DisregardTenGigabitEthernet1/1/3

DisregardTenGigabitEthernet1/1/4

C9300-NM-4M Module

Table 3: C9300-NM-4M Module with 4 Multigigabit Ethernet (mGig) Module

ActionInterface

Configure this interfaceTenGigabitEthernet1/1/1

Configure this interfaceTenGigabitEthernet1/1/2

Configure this interfaceTenGigabitEthernet1/1/3

Configure this interfaceTenGigabitEthernet1/1/4

Installing a Network Module

C9300-NM-4G Module

Other manuals for Cisco Catalyst 9300 Series