Cisco Catalyst 9300 Series

To Next Page

To Previous Page

ActionInterface

DisregardTenGigabitEthernet1/1/2

DisregardTenGigabitEthernet1/1/3

DisregardTenGigabitEthernet1/1/4

C3850-NM-4-10G Module

All ports in the C3850-NM-4-10G module default to 10 G and should be configured as TenGigabitEthernet1/1/1

through TenGigabitEthernet1/1/4, even when you are operating them as 1 G using SFPs. Only four interfaces

are valid; the other four should not be used even though they still show up in the CLI.

Table 7: C3850-NM-4-10G Module

ActionInterface

DisregardGigabitEthernet1/1/1

DisregardGigabitEthernet1/1/2

DisregardGigabitEthernet1/1/3

DisregardGigabitEthernet1/1/4

Configure this interfaceTenGigabitEthernet1/1/1

Configure this interfaceTenGigabitEthernet1/1/2

Configure this interfaceTenGigabitEthernet1/1/3

Configure this interfaceTenGigabitEthernet1/1/4

C3850-NM-2-10G Module

In the C3850-NM-2-10G module, the first two parts are natively 1-G ports and the last two ports are natively

10-G ports. So, you configure the 1-G posts as GigabitEthernet1/1/1 through GigabitEthernet1/1/2, and

configure the last two ports as TenGigabitEthernet1/1/3 through TenGigabitEthernet1/1/4, even when you

are operating the last two ports as 1-G. Only four interfaces are valid, and the other four should not be used

even though they still show up in the CLI.

Table 8: C3850-NM-2-10G Module

ActionInterface

Configure this interfaceGigabitEthernet1/1/1

Configure this interfaceGigabitEthernet1/1/2

DisregardGigabitEthernet1/1/3

DisregardGigabitEthernet1/1/4

DisregardTenGigabitEthernet1/1/1

Installing a Network Module

C3850-NM-4-10G Module

Other manuals for Cisco Catalyst 9300 Series