Cisco Catalyst 9407R User Manual

Step 3 Close the terminal block cover and finger-tighten the captive installation screw (approximately 0.25 Nm).
Removing a DC-Input Power Supply Module from the Chassis
To remove a DC-input power supply module from the chassis, follow the steps described here.
Before you begin
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Procedure
Step 1 Pull out the latch on the module, to unlock it.
Comparative location of the nut on a module
where the release latch has not been pulled out.
3Release latch to be pulled out (towards yourself)1
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
115
Removing and Replacing FRUs
Removing a DC-Input Power Supply Module from the Chassis

Cisco Catalyst 9407R Specifications

General

Model	Cisco Catalyst 9407R
Category	Switch
Chassis Slots	7
Rack Units	10 RU
Form Factor	Rack-mountable
Slots	7
Maximum Number of Line Cards	5
Operating System	Cisco IOS XE
Product Type	Modular Switch
Power Supply Options	AC and DC
Redundancy	Yes