Cisco Catalyst 9407R

CHAPTER 5
Installing the Switch
• Installation Tasks , on page 47
• Unpacking the Switch, on page 49
• Install the Switch as Shipped, on page 50
• Install the Switch with Shelf Brackets, on page 53
• Installing the Cable Guide, on page 65
• Install the Switch in a NEBS-Compliant Mode, on page 70
• Establishing System Ground, on page 79
• Attaching an ESD Strap, on page 81
• Verifying the Switch Chassis Installation, on page 84
Installation Tasks
These warnings apply to the overall switch installation process:
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each
warning to locate its translation in the translatedsafety warnings that accompanied thisdevice.Statement
1071
SAVE THESE INSTRUCTIONS
Warning
Class 1 laser product. Statement 1008
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
47