Performing the Initial Configuration on the Controller
Using the Cisco IOS-XE CLI - Cisco Setup Command Facility
The setup command facility prompts you to enter the information that is needed to configure a controller
quickly. The facility takes you through an initial configuration, including wireless configurations.
The setup command facility is entered automatically if there is no configuration on the controller when it is
booted into Cisco IOS-XE.
Note
Do not delete Throughput.txt file. This file is created when the license wireless high-performance command
is used on the controller to increase the scale from 250 APs and 5000 clients to 500 APs and 10000 clients.
Deleting this file will revert the controller to the previous state of 250 APs and 5000 clients.
Note
You will be prompted for wireless configuration after the Day 0 banner.
For information on modifying the configuration after you create it, see the Cisco Catalyst 9800 Series Wireless
Controller Software Configuration Guide and the Cisco Catalyst 9800 Series Wireless Controller Command
Reference Guide.
This section covers the following:
• Configuring the device management interface.
• Configuring the device management IP.
• Setting a static route.
• Configuring the management credentials.
• Configuring the wireless management interface.
• Choosing the deployment mode.
• Configuring the system name or hostname.
• Configuring credentials for management access on access points.
• Configuring the country code.
• Configuring the time using an NTP server or manually.
• [Optional] Configuring a time zone.
• [Optional] Configuring the wireless client density.
• [Optional] Configuring AAA servers.
• [Optional] Configuring the wireless network settings.
• [Optional] Configuring a network name or SSID.
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
32
Power Up and Initial Configuration
Performing the Initial Configuration on the Controller
To Next Page
Loading...
Need help?
General
