2. Active
3. Standby
Enter your selection [1]:
You can choose from one of the following deployment modes:
• Standalone: In this mode, you do not get to view any high availability pairing information.
• Active: In this mode, the controller needs to be configured with all the Day 0 information.
• Standby: In this mode, the configuration proceeds to the High Availability configuration.
Note
Step 13 Configure the system name or hostname:
Enter the hostname [WLC]: ciscowlc
This is a mandatory step. The hostname needs to confirm to the RFC standards.
Note
Step 14 [Optional] Configure the login credentials for an AP.
Configure credentials for management access on Access Points? [yes]:
Enter the management username: cisco
Enter the management password: ****
Reenter the password: ****
Enter the privileged mode access password: ****
Reenter the password: ****
Step 15 Configure the country code. You can specify multiple country codes by separating them with a comma.
Configure country code for wireless operation in ISO format ? [US]:
Step 16 Configure the date and NTP to allow access points to join the controller. You can configure time using an
NTP server or manually.
You need to enter time in the following format:
DAY-MONTH-YEAR
Note
Configure NTP server ? [yes/no]: no
Enter the day:
Enter the month:
Enter the year:
Configure a NTP server now? [yes]:
Enter ntp server address : 9.11.112.45
Enter a polling interval between 16 and 131072 secs which is power of 2: 16
Step 17 [Optional] Configure a timezone:
Configure timezone? [yes]:
Enter name of timezone: ind
Enter hours offset from UTC (-23,23): 5
Enter mins offset from UTC (0,59) [0]: 30
Step 18 [Optional] Configure the expected client density:
Configure Wireless client density? [yes]:
Choose the client density
1. Low
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
35
Power Up and Initial Configuration
Day 0 CLI Wizard for the Controller
To Next Page
Loading...
Need help?
General
