Configure virtual IP? [yes]:
Enter the virtual IP [192.0.6.1]:
Step 23 [Optional] Configure an RF network name.
Configure RF-Network Name? [yes]:
Enter the RF-Network Name: ciscorf
Step 24 [Optional] Configure high availability.
If you choose the deployment mode as Active or Standby, you will need to choose from one of the HA pairing
type:
a. RMI
b. RP-RP
For information on HA pairing types, see Part: High Availability (High Availability > Information
About Redundancy Management Interface) in Cisco Catalyst 9800 Series Wireless Controller
Software Configuration Guide, Cisco IOS XE Bengaluru 17.4.x.
Note
High Availability configuration
Please choose the HA pairing type
1. RMI
2. RP-RP
Enter your selection [1]:
If you choose RMI+RP, you need to select an interface to be used as redundancy port:
Enter the RMI IP for local chassis: 9.11.112.12
Enter the RMI IP for remote chassis: 9.11.112.13
Enter the gateway IP of the last resort: 9.11.112.1
If you have not configured a default route earlier, you need to enter the gateway IP of the last resort.
Note
If you choose the deployment mode as Standby, you need to specify the VLAN ID for completing the pairing:
Enter the RMI IP for local chassis: 9.11.112.51
Enter the RMI IP for remote chassis: 9.11.112.50
Enter the wireless management VLAN: 112
If you choose RP, you need to select an interface to be used as redundancy port:
Select interface to be used as redundancy port
1. TwoGigabitEthernet0/0/2 [Up]
2. TwoGigabitEthernet0/0/3 [Up]
Choose the interface to config [1]: 2
Enter the local IP:
Enter the subnet mask:
Enter the remote IP:
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
37
Power Up and Initial Configuration
Day 0 CLI Wizard for the Controller
To Next Page
Loading...
Need help?
General
