17
Getting Started and Product Document of Compliance for the Cisco Catalyst IW6300 Heavy Duty Series Access Points
EMC Information
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Cisco® Catalyst IW6300 Heavy Duty Series Access Point Model
IW-6300H
Cisco® Catalyst IW6300 Heavy Duty Series Access Point PIDs
IW-6300H-AC-E-K9
IW-6300H-DC-E–K9
IW-6300H-DCW-E-K9
Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive
93/42/EEC
The following standards were applied:
EMC-EN 301.489-1 v1.9.2; EN 301.489-17 v2.2.1
Health & Safety-EN60950-1: 2005; EN 50385: 2002
Radio-EN 300 328 v 1.9.1; EN 301.893 v 1.7.1, EN62311
The conformity assessment procedure referred to in Article 10.4 and Annex III of Directive 1999/5/EC has been followed.
This device also conforms to the EMC requirements of the Medical Devices Directive 93/42/EEC.
NOTE: This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain
frequencies and/or may require a license for operation. For more details, contact Cisco Corporate Compliance.
The product carries the CE Mark:
Declaration of Conformity for RF Exposure
This section contains information on compliance with guidelines related to RF exposure.
Generic Discussion on RF Exposure
The Cisco products are designed to comply with the following national and international standards on Human Exposure
to Radio Frequencies:
US 47 Code of Federal Regulations Part 2 Subpart J
American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers / IEEE C 95.1 (99)
International Commission on Non Ionizing Radiation Protection (ICNIRP) 98
Ministry of Health (Canada) Safety Code 6. Limits on Human Exposure to Radio Frequency Fields in the range from
3kHz to 300 GHz
Australia Radiation Protection Standard
To Next Page
Loading...
Need help?
General
