43
Installing and Connecting the Router
Connecting to the Auxiliary Port
Uninstalling the Cisco Microsoft Windows Vista USB Driver, page 43
Uninstalling the Cisco Microsoft Windows XP and 2000 USB Driver
You can remove Microsoft Windows XP and the 2000 USB driver using the Windows Add or Remove Programs utility or
the setup.exe program.
To uninstall both the Microsoft Windows XP and 2000 USB driver using the Add Remove Programs utility:
Note: Disconnect the router console terminal before uninstalling the driver.
1. Click Start > Control Panel > Add or Remove Programs.
2. Scroll to Cisco Virtual Com and click Remove.
3. When the Program Maintenance window appears, select the Remove radio button, then click Next.
To uninstall both the Microsoft Windows XP and 2000 USB driver using the Setup.exe program:
Note: Disconnect the router console terminal before uninstalling the driver.
1. Run the setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
2. The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
3. When the Program Maintenance window appears, select the Remove radio button, then click Next.
4. When the Remove the Program window appears, click Remove.
5. When the InstallShield Wizard Completed window appears, click Finish.
Uninstalling the Cisco Microsoft Windows Vista USB Driver
To uninstall the Microsoft Windows Vista USB driver:
Note: Disconnect the router console terminal before uninstalling the driver.
1. Run the setup.exe file for Windows 32-bit or the setup(x64).exe file for Windows 64-bit. Click Next.
2. The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
3. When the Program Maintenance window appears, select the Remove radio button, then click Next.
4. When the Remove the Program window appears, click Remove.
Note: If a User Account Control warning appears, click “Allow - I trust this program...” to proceed.
5. When the InstallShield Wizard Completed window appears, click Finish.
Connecting to the Auxiliary Port
When a modem is connected to the auxiliary port, a remote user can dial in to the router and configure it.
To connect a modem to the router:
1. Connect the RJ-45 end of the adapter cable to the black AUX port on the router (Figure 15 on page 44).
To Next Page
Loading...
Need help?
General
