Cisco CLI - View Mode User Password; Ethernet Port Parameters

Command-line interface user manual
_________________________________________________________________________________________________
__________________________________________________________________________
© 2021 Cisco and/or its affiliates. All rights reserved Page 19 of 37
8.2. View Mode user password
Configuration objective
CLI command
Parameter options
NEW I Set the View Mode
user password for access to the
device’s offline Configurator
interface and CLI.
viewmode-user
username F passwd G
Parameter F is the new view-
mode user name.
Parameter G is the new
password.
8.1. Ethernet port parameters
Configuration objective
CLI command
Parameter options
NEW I Show the current
configuration for a specific
Ethernet port on the device.
ethernet port A
Parameter A is the number of
the Ethernet port being
queried.
Possible values for A are eth 1
(LAN 1 port) or eth 2 (LAN 2
port).
NEW I Set the maximum port
speed for the device’s Ethernet
ports.
ethernet port A
speed B
Parameter A is the number of
the Ethernet port (or SFP
interface) whose speed is
being modified. Possible
values for A are eth 1 or eth 2.
Parameter B is the data
transfer speed for the relevant
port. Ethernet port speeds are
expressed in Mbps. Possible
values for B are 10, 100, or
auto.
NEW I Set the duplex mode
for the device’s Ethernet ports.
ethernet port A
duplex C
Parameter A is the number of
the Ethernet port for which the
duplex mode is being set.
Parameter C is the port duplex
mode. Possible values for C
are half or full.
NEW I Change the size of the
Ethernet maximum
transmission unit (MTU) for the
device ports.
ethernet mtu D
Parameter D is the port MTU
size setting in bytes. The value
can be set between a minimum
of 1530 and a maximum of
1650 for FM1200V, FM3200,
FM4200 and 2000 for FM3500
and FM4500..
8.2. Hardware Reset button
Configuration objective
CLI command
Parameter options
Set the device’s hardware
Reset button to trigger:
• A unit reboot if the button is
reset-button enable
IMPORTANT
Before changing the View Mode user password, make sure
that the password is known to all personnel who will use it.
When a password has been entered, the system cannot
recall it or display it for reference.