Cisco CLI - Managing Plug-in Licenses; Network Time Protocol (NTP) Settings

Command-line interface user manual
_________________________________________________________________________________________________
__________________________________________________________________________
© 2021 Cisco and/or its affiliates. All rights reserved Page 21 of 37
entered during the current
session.
8.1. Adding, removing and showing installed plug-in licenses
Configuration objective
CLI command
Parameter options
Show a complete list of the
software plug-in licenses that
are currently installed on the
device.
plugins
NEW I Add a new software
plug-in license to the radio
transceiver.
plugins add B
Value B is the activation code
for the relevant plug-in license.
NEW I Delete a new software
plug-in license from the radio
transceiver.
plugins remove C
Value C is the name of the
relevant plug-in license.
8.2. Showing the device model and firmware revision number
Configuration objective
CLI command
Parameter options
Show the device model and
firmware revision number.
version
8.3. Showing the device mesh ID number
Configuration objective
CLI command
Parameter options
Show the device’s Cisco mesh
ID number.
meshid
8.4. Show an engineering statistics summary
Configuration objective
CLI command
Parameter options
Show an instantaneous
summary of current engineering
statistics for the device.
eng-stats
Show a summary of
engineering statistics for the
device that is updated once per
second.
eng-stats refresh
8.5. Network Time Protocol settings
Configuration objective
CLI command
Parameter options
Synchronize the device’s time
settings with a chosen internet
time server by activating
network time protocol (NTP).
ntp Q
Possible values for Q are
enable or disable.
Synchronize the device with a
chosen primary NTP server.
ntp server R
Value R is the URL of the
chosen primary NTP server.
Synchronize the device with a
chosen backup NTP server.
ntp server2 S
Value S is the URL of the
chosen secondary NTP server.
Set the designated time zone in
which the device is located.
ntp timezone T
Value T is the local time zone.
Composite names must be
bracketed with double quotation
marks. A typical example might
read “America/New York”.
Set the time and date
immediately, instead of waiting
ntp set