Cisco CLI - Cloud-Management Settings

Command-line interface user manual
_________________________________________________________________________________________________
__________________________________________________________________________
© 2021 Cisco and/or its affiliates. All rights reserved Page 23 of 37
8.8. Transport Layer Security settings
Configuration objective
CLI command
Parameter options
Show the versions of TLS that
are supported by the device.
tls
Restrict the device’s TLS
support capability to TLS 1.2
only.
tls 1.2-only A
Possible values for A are
enabled or disabled.
If the disabled command is
executed, the device will
support TLS 1.0, 1.1 and 1.2.
8.9. Device cloud-management settings
Configuration objective
CLI command
Parameter options
Activate or deactivate Cisco
RAdio Configuration
EnviRonment (RACER)
configuration capability.
racer B
Possible values for B are:
• online-cloud-managed (the
device will take its
configuration settings from
the cloud-based RACER
profile that is assigned to it.)
• offline (the device is
disconnected from RACER
and must be manually
configured using the CLI, or
its offline Configurator
interface.)
8.10. MONITOR settings
Configuration objective
CLI command
Parameter options
View the device’s current Cisco
Radio Monitoring Dashboard
(MONITOR) connection status.
monitor
Possible values for L are
enable or disable.
Disconnect the device from
MONITOR.
Note that the device can be re-
connected to MONITOR at any
monitor detach
Possible values for L are
enable or disable.
NOTE
Cisco hardware devices feature support for all versions of
transport-layer security (TLS).
NOTE
For instructions on how to configure your Cisco device
using the cloud-based RACER portal, refer to the Cisco
RACER configuration manual.
NOTE
For instructions on how to do operational monitoring and
gather statistics from your Cisco device using the
MONITOR application, refer to the Cisco Radio Monitoring
Dashboard Configuration Manual.