Cisco CLI - Link Layer Discovery Protocol (LLDP) Settings; Device Firmware Upgrade Settings; CLI Session Time-out

Command-line interface user manual
_________________________________________________________________________________________________
__________________________________________________________________________
© 2021 Cisco and/or its affiliates. All rights reserved Page 24 of 37
time, using the MONITOR
application.
8.11. Link Layer Discovery Protocol settings
Configuration objective
CLI command
Parameter options
Activate LLDP capability.
lldp B
Possible values for B are
enable or disable.
Enable or disable the link layer
discovery protocol-data SNMP
management information
database.
lldp snmp-mib C
Possible values for C are
enable or disable.
Show neighboring devices that
are also LLDP-enabled.
lldp neighbors
8.12. Multicast settings
Note that as the FM Ponte 50 is configured to work in Bridge mode only,
multicast capability can only be enabled or disabled.
Configuration objective
CLI command
Parameter options
NEW I Enable or disable
multicast forwarding capability.
multicast status D
Possible values for D are
enable or disable.
8.13. Device firmware upgrade settings
These settings allow you to upgrade the firmware of the connected Cisco
device using trivial file transfer protocol (TFTP).
Configuration objective
CLI command
Parameter options
Specify the IP address of the
TFTP server containing the
needed firmware image.
tftp-fw-upgrade
tftp-server D
Value D is the IP address of the
TFTP server.
Specify the file name of the
needed firmware image.
tftp-fw-upgrade
upgrade-fw-image E
Value E is the file name of the
needed firmware image.
Enable or disable automated
firmware upgrades.
tftp-fw-upgrade
automatic-upgrade
F
Possible values for F are
enable or disable.
Specify the periodic interval at
which the device checks for the
presence of a newer firmware
upgrade package.
tftp-fw-upgrade
check-period G
Value G is the automatic
upgrade check period in hours.
Force an immediate check for a
newer firmware upgrade
package.
tftp-fw-upgrade
check-now
8.14. Enabling a CLI session time-out
Configuration objective
CLI command
Parameter options
NEW I Specify an ‘inactive’
time period after which, if user
activity is still not detected
within the CLI console, the
current user will automatically
be logged out.
session-timeout O
Value O is the specified
‘inactive’ time period in minutes
after which the current user will
automatically be logged out.
Possible values for O are:
• 1 to 35791 (i.e. a maximum
inactive period of 596
hours.)
• 0 (time-out option disabled.)