Cisco CLI - Committing Configuration Settings; Rebooting the Device; Discarding Configuration Changes; Resetting to Factory Defaults

Command-line interface user manual
_________________________________________________________________________________________________
__________________________________________________________________________
© 2021 Cisco and/or its affiliates. All rights reserved Page 20 of 37
pressed for one second
and released.
• A factory reset if the button
is pressed for 7 seconds
and released.
Set the device’s hardware
Reset button to trigger a factory
reset if the button is pressed for
7 seconds and released (the
unit reboot option will be
unavailable).
reset-button
factory
Disable the hardware Reset
button functionality.
reset-button
disable
8.3. Telnet functionality
Configuration objective
CLI command
Parameter options
Enable or disable the device’s
Telnet capability.
telnet A
Possible values for A are on or
off.
8.4. Committing configuration settings to memory
Configuration objective
CLI command
Parameter options
Commit the current
configuration settings to
memory.
write
8.1. Rebooting the device
Configuration objective
CLI command
Parameter options
Reboot the device immediately.
reboot
8.2. Discarding configuration changes made during the
current session
Configuration objective
CLI command
Parameter options
Discard all configuration
changes made during the
current session.
discard
8.3. Resetting the unit to factory default condition
Configuration objective
CLI command
Parameter options
Reset the unit to factory default
condition.
factory YES
Note that YES must be typed in
capitals.
8.4. Showing command-line history for the current session
Configuration objective
CLI command
Parameter options
Show a complete list of all CLI
commands that have been
history
IMPORTANT
After the write command is entered, you must re-boot the
device for the current configuration to take effect.