Cisco CLI - Wireless Interface Configuration

Command-line interface user manual
_________________________________________________________________________________________________
__________________________________________________________________________
© 2021 Cisco and/or its affiliates. All rights reserved Page 15 of 37
commands, refer to
https://www.mankier.com/1/iperf.
8.7. Connecting to a remote host using SSH
Configuration objective
CLI command
Parameter options
Connect the device to a remote
host using Secure Shell.
ssh C
Parameter C is the hostname
or IP address of the remote
host.
8.8. Pinging the configured device
Configuration objective
CLI command
Parameter options
Send a ping from the hardware
device to another, specified
hardware device.
ping A
Parameter A is the IP address
of the hardware device that is
not the local device.
Set the ping count (in other
words, to stop pinging after a
specified number of packets).
ping -c B
Parameter B is the specified
number of echo request
packets (optional).
8.9. Tracing the route from the device to its connected host
Configuration objective
CLI command
Parameter options
Return a description of the
connected route from the local
device, to its specified host (A).
traceroute A
Parameter A is the hostname
of the specified host.
Specify the maximum number
of hops included in the
traceroute result.
traceroute -m B
Parameter B is the specified
maximum number of hops.
Note that the maximum
number of hops cannot exceed
255.
8.10. Wireless interface
Configuration objective
CLI command
Parameter options
Show the active parameters of
the wireless interface.
wireless
Set the frequency, channel
width and status parameters to
be changed at runtime, without
having to reboot the device.
wireless live
Set the device’s operating
frequency.
wireless frequency
A
Parameter A is the specified
frequency in MHz.
Set the device’s operating
channel width.
wireless cwidth B
Parameter B is the specified
channel width in MHz.
Depending on radio transceiver
type, possible channel width
values are 5, 10, 20, 40 or 80.
Enable and disable advanced
encryption standard (AES)
traffic encryption.
wireless crypto C
Possible parameters for C are
enable and disable.
Set the device’s mesh network
wireless passphrase
Parameter D is the network
IMPORTANT
If commands and values from this section are entered, they
are validated in accordance with the installed software plug-
ins and the regulatory mode to which the device has been
set.